Beko GmbH

 Bekosplit

BEKOSPLIT separates oil water emulsions - Effectively

When dealing with oil water emulsion which is one of the most dangerous effluents, emulsions are oil being blended into water molecules or vice versa, making them relatively harder to separate compare to normal oily condensates.

Conventional method such as water treatment plant that uses plenty of chemicals.  It does not make sense to use chemicals to separate emulsions, and create more harmful chemical byproducts.  Bekosplit does it the most environmental friendly way.

Bekosplit - Emulsion separator with fully automated function to work round the clock unsupervised.  Emulsions are fed into Bekosplit from a pre-separation tank, the emulsions are then added with mineral based treating agent.  With built-in motorized stirrer, the treating agent dissolves into the emulsion, and break the emulsion's molecular bond.  This will eventually form a solidified oil residue, leaving clean water behind.  The oil residue is then filtered automatically into durable filter bags, dewatered, and ready to be collected for scheduled waste.

Bekosplit is able to process and treat emulsion from 15 liter/hour to 160 liter/hour, making it the best splitting plant in its class.

Typical applications are

• Emulsion condensates from compressed air system
• Washing water, e.g., from vehicle cleaning or road cleaning
• Leak test liquids
• Bilge water

Fact: 1 liter of oil can contaminate 1,000,000 liters of ground water.

Pre-separation tank with pressure relief chamber                                            

Emulsion wastewater flows into the pre-separation tank via a pressure relief chamber. The initial stage of pure oil separation will take place, therefore, the consumption of treating agent can considerably reduced, and filter lifetime can significantly prolonged.

Filtration through durable filter bags                                                                 

After being separated by treating agent, the solidified oil residue is transferred into filter bags where dewatering process begins. 

Do remember that scheduled waste contractors charge according to the weight of the waste.

• Low water content of  residue due to large filter surface area

• Filter cake consists of non-leachable residue mass

• Low filter consumption owing to filtration through bag filters

• Simple and fast filter replacement

Treating agent                                                                                                  

The broad-range (pH 4 to 10), highly effective treating agent eliminates not only the need for the continual adaptation of pH values, but also for the use of chemicals.

Fully automated                                                                                                 

• Microprocessor control of all running sequences

• Monitoring of the treating agent supply and amount dispensing

• Permanent filter monitoring

• Maintenance and alarm messages can be processed externally via signal outputs

• The electronic control and monitoring enables fully automated operation

Emulsion Separator Bekosplit Performance Chart